EasyManua.ls Logo

Janome 5270QDC - Clasp Stitch, Satin & Decorative Stitches

Janome 5270QDC
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
57
Fagoting
q Stitch pattern: MODE 2: 69
w Thread tension dial: 3 to 6
e Presser foot: Satin stitch foot F
* The stitch patterns 70, 77 in mode 2 and 31, 32 in mode
3 can also be used.
Use these stitches to join two pieces of fabric to create
an open work appearance and add design interest.
Fold under each fabric edge 5/8˝ (1.5 cm) and press.
Pin the two edges to paper or tear backing 1/8˝ (0.30.4
cm) apart.
Sew slowly, guiding the fabric so the needle catches the
folded edge on each side.
After sewing is nished, tear away the paper.
q 1/8˝ (0.30.4 cm)
w Paper
4
q w e
q
w
w eq
French Knots and Candlewick Knots
q Stitch pattern: MODE 3: 01 - 04
w Thread tension dial: 5 to 8
e Presser foot: Satin stitch foot F
Scallop Stitch
q Stitch pattern: MODE 2: 56
w Thread tension dial: 3 to 6
e Presser foot: Zigzag foot A
* The stitch patterns 69 and 86 in mode 3 can also be
used.
4
q
w
e
Sew the stitches approximately 3/8˝ (1 cm) inside the
fabric edge.
Trim the outside of the stitches as shown. Make sure not
to cut the thread.
Select the stitch pattern 01 in mode 3 for French knots.
Select the stitch pattern 02-04 in mode 3 for Candlewick
knots.
Tighten the thread tension to 5-8 when sewing.

Table of Contents

Other manuals for Janome 5270QDC

Related product manuals