Janome 5300QDC - Page 22

20
Snap ring
Nut
Wire (unit)
Nut
Snap ring
Wire (unit)
Nut
MECHANICAL ADJUSTMENT
REPLACING AND ADJUSTING THE KNEE LIFTER WIRE UNIT (1)
TO REPLACE KNEE LIFTER WIRE:
To remove:
1. Remove the free arm cover, base plate, front cover and rear cover (see pages 5 to 8).
2. Remove snap rings (2 pcs.).
3. Loosen nuts (3 pcs.).
4. Remove the wire (unit).
To attach:
5. Follow the above procedure in reverse.
After replacing the knee lifter wire (unit), follow the adjustment procedure on the next page.