22
REPLACING AND ADJUSTING THE NEEDLE THREADER HOLDER (1)
If the hook of the needle threader holder is damaged, change or adjust the part as follows:
To replace:
1. Remove the setscrew to remove the needle threader holder.
2. Prepare the replacement parts (order them as necessary).
q 858266009: Link plate 2
w 862627108: Hook holder (unit)
e 862626026: Threader plate (unit)
r 858265008: Link plate 1
t 000230403: Setscrew t
3. Assemle the parts q, w and r as shown in FIG. 1.
4. Attach the part e to the assembled parts as shown in FIG. 2.
5. Attach the assembled parts with the setscrew t.
Be sure that the pin of the link plate is inserted in the slit as shown.
Adjust the needle threader hook position (see to the next page).
MECHANICAL ADJUSTMENT
q w e r t
Setscrew t
Setscrew
FIG. 1 FIG. 2
To Next Page
Loading...
