Janome 6260QC - Winding the Bobbin; Removing the Bobbin; Setting the Spool of Thread; Additional Spool Pin

Setscrew 4 x 8
Presser bar lifter
<Presser bar height>
Zigzag foot
Needle plate
Should be parallel
<Presser foot alignment>
Feed dog
6.0 mm
Mechanical Adjustment
Presser Bar Height and Alignment
When the presser foot is raised, the clearance between the presser foot and the needle plate should be 6.0 mm.
When the presser foot is lowered, the edge of the foot and the feed dog window on the needle plate should be
parallel.
Remove the face cover and raise the presser foot. Loosen the setscrew to adjust the presser foot height (6.0 mm)
and the presser foot alignment.
Tighten the setscrew firmly.
Attach the face cover.
Feed dog window
11