Replacing DC Motor
To remove:
1. Remove the front cover (See page 8.).
2. Remove the board supporter (see page 23) and unplug the DC motor connector.
3. Remove the 2 setscrews (A) and replace the DC motor.
To attach:
4. Follow the above procedure in reverse.
To adjust motor belt tension:
1. Slightly loosen the 2 setscrews (A). Move the motor to adjust the motor belt tension so that the belt is
bent 7-9 mm when pressing the middle of the belt with approximately 300 grams of pressure.
2. Tighten the setscrews.
Deflection: 7 to 9 mm
300g loard
Motor
Setscrew (A)
28
To Next Page
Loading...
