Janome HD9 - Inserting a Bobbin; Inserting the Bobbin Case into the Hook

18
z
Place a bobbin in the bobbin case making sure the
thread winds clockwise on the bobbin as illustrated.
x
Draw the thread through the slit
q
of the bobbin case.
q
Slit
c
Continue to draw the thread under the tension
spring
w
and through the opening
e
.
Pull out about 4˝ (10 cm) of thread.
The bobbin should spin clockwise when the thread
is pulled out of the bobbin case.
w
Tension spring
e
Opening
Inserting a Bobbin
Inserting the Bobbin Case into the Hook
* Be sure that the needle is at its highest position.
z
Holding the latch
q
open, position the bobbin case
into the hook aligning the bulge
w
with the
concave
e
.
The bobbin case should lock into place when the
latch is released.
q
Latch
w
Bulge
e
Concave
* Leave the tail of the bobbin thread to the left as
shown.
x
Close the hook cover
r
and attach the hook cover
plate
t
in this order.
r
Hook cover
t
Hook cover plate
1
2
3
z
x
r
t
q
w
e
z
x
c
q
e
w