19
Attaching the darning foot PD-H
Attach the darning foot PD-H to the presser bar by putting
the pin on the needle clamp screw.
q Pin
w Needle clamp screw
Tighten the thumbscrew firmly with the screwdriver.
Attaching the embroidery foot P
Attach the embroidery foot P to the presser bar from
behind.
Refer to page 99.
Detaching and attaching the dual feed foot
Pull the foot toward you to remove it.
Insert the pins of the foot into the slits of the foot holder
and gently push the foot until it snaps into place.
q Pin
w Slit
q
w
q
w
To Next Page
Loading...
