26
Needle stop position setting
The machine always stops with the needle in the down
position except when sewing buttonholes, specialty
stitches, monograms, etc. However you can select the
needle stop position to up or down.
Enter the setting mode. Press the mode key to enter the
needle stop position setting.
The default needle stop position setting is down position
“dn”.
To change the needle stop position, press the cursor
key “ ” and the “UP” mark will blink.
Start-up speed setting
The machine will start running slowly and the sewing
speed will gradually increase to maximum when pressing
the start/stop button.
Youcanselectthedesiredstart-upspeedfrom1(slow)q,
2 (medium) w or 3 (high) e.
Enter the setting mode. Press the mode key twice to
enter the start-up speed setting.
The default start-up speed setting is “1” (slow). To change
the start-up speed, press the cursor key “ ” or
“ ”, and the selected speed number will blink.
q
w
e
Resetting all to default
The following customized settings can be reset to the
original settings (factory settings).
•Buzzersound
•Needlestopposition
•Startupspeedsetting
Enter the setting mode. Press the mode key 3 times to
enter the Resetting all to default mode.
Press and hold the clear key until the machine beeps to
reset the machine to the factory default setting.
Janome 8200 Sewing Machine Instruction Manual
MC8200 Owners Manual/ User Guide
To Next Page
Loading...
