Janome Memory Craft 8200QC - Square Buttonhole - Adjustments; Adjusting Buttonhole Width; Adjusting Buttonhole Stitch Density

JanomeFlyer.com
46
v Mark the buttonhole position on the fabric and place
it under the buttonhole foot. Lower the needle at the
starting point by turning the hand wheel.
u Starting point
u
NOTE:
Make sure there is no gap between the slider and
front stopper, otherwise the buttonhole will be out of
position or there will be a sewing gap.
i No gap
o Starting point
!0 Sewing gap
i
o o o
!0
!0!0
b Start sewing while pulling the needle thread lightly to
the left. After sewing a few stitches, free the thread
and continue sewing.
v
b
Janome 8200 Sewing Machine Instruction Manual
www.janomeflyer.com
MC8200 Owners Manual/ User Guide