29
TO ADJUST THE FEED DOG UP/DOWN FUNCTION
The feed dog drops automatically when selecting embroidery sewing and rises auto-matically
when selecting normal stitches.
1. Remove the carriage cover cap.
(Pull the carriage away from the machine a little and pry off the cover cap with a
screwdriver, as shown below.)
2. Loosen the two screws.
3. If the drop feed finger does not fit into the notch in the drop feed knob (when embroi-dery
sewing is selected on The touch panel), slide the drop feed finger right or left until it goes
in.
4. Tighten the screws.
5. Attach the carriage cover cap.
6. Check the feed dog up/down position with the touch panel. (Use “ADY key func-tion.)
To Next Page
Loading...
