Drawing up Bobbin Thread
Comment Faire Remonter le Fil de la Canette
!
(_ Hold the needle thread tightly with your left
hand.
(_) Turn the balance wheel slowly towards you
with your right hand until the needle goes
dawn and continue turning balance wheel
until the take-up lever is at its highest position.
LightJy draw up the needle thread forming a
loop with the bobbin thread.
\
(_) Pull t5 cm (6") of both threads back and
under the presser foot.
(_ Tenez ldgkrement avecla main gauche.
(_) Tournez tentement te volant vers vous jusqu_
ce que l'aiguille descende, Continuez
tourner le volant /usqu'a ce que le levier
relever salt d ta position ta plus gtevge.
Retirez lentement te fil de l'aiguitle en
formant une boucle avee fil de la canette,
@ Tirez 15 cm (6"') des duex ills vers l'arri#re
et sous le pied-de-biehe,
19
To Next Page
Loading...
