Janome mystyle 16 - Straight Stitches; Straight Stitch; Use the Seam Guides; Turn a Square Corner

SECTION 3.
LEARN THE STITCHES
Straight Stitches
Straight Stitch
Use the Seam Guides
Set the Machine
Stitch
width
N
control
0
111
Cornering qurde
Top thread
tension
The seam guides on
the needle plate
control 2 to 6
Stitch length
are engraved to help you
measure seam
\ control cink
Before sewing with the
straight stitch 7. At the
beginning and end of
width. The lines are 1/8"
apart, with
zone
foot, always set
the stitch width
seam, you may want to
reverse to the 5/8"
and 7/8" lines marked.
--][4L7i ,
"
3
control to
0 to avoid breaking the
lock the stitch.
'9/
*Turn a Square Corner
j63 needle.
8. Raise the
presser
foot and remove
o4
1. Raise the presser foot.
the fabric.
2. Raise the needle
to its highest 9. Cut
the threads.
<Cornerroy
Stretch
Stitch
position.,"
-
4
c
de
H h3.
Place the edge
of the fabric next
H: Straight foot
to a stitching
guide line on the
< --
needle plate (5/8" is
most
NOTE:
Best sewing results
are common).
obtained
with the straight
4. Draw the
threads toward the
back
stitch
foot, but the
zigzag
andTo
turn
a square corner
5/8" from the
fotwl
lo
poie
and
lower
the
presser
foot.
fabric
edge:ý
foot will also provide
acceptable results.
5. Press the
foot control.
1. Stop
stitching and lower
the
6.
Hold
the fabric
loosely
and
gently
needle
by turning
hand
wheel
guide
it along
the
guide
line,
so
toward
you
when
the
fabric
edge
that
it feeds
naturally.
facing
you
lines
up
with the
Do
not
force
the
fabric
or
try
o
cornering
guide,
as
shown.
pullit
tight.
2,
Raise the presser
foot and turn
the
fabric
to
line
the
edge
with
the 5/8 seam guide.
3. Lower
the presser
foot and
begin
stitching
in the new
direction.
25