Janome mystyle 16 - Blind Hemming

SECTION
3. LEARN THE STITCHES
Blind Hemming
Set the Machine
Stitch
width
control
2
to
3
0f4
to 0.7
cm
Bottom
side
of
fabric
WeIgh
Top
thread
tension
tr
control
2 0o 6 Stitch length
control
pink
zone,2ev
o
Fabric
1. Finish the raw
edge of your hem any way you desire.
(see overcasting page 33).
Stretch
Stitch
2.
Measure,
turn
up
your
hem
and
pin.
{M c
NOTE: For light weight fabrics, you
may need a double fold.
A; Zigzag
foot 3.
Fold the material (bottom side out)
on the edge to be stitched, as shown,
leaving 0.4 to 0.7 cm of the finished hem
edge showing.
4.
Place garment under presser foot in such
a manner that straight stitches will be
sewn on extended edge. The zigzag
stitch should just catch the
fold of the garment.
5. After
hemming, press both sides of the
finished hem. The top side of the
garment will show only the blind
stitches.
36