Janome SKYLINE S6 - DC Motor Replacement

11
Replacing electronic components
DC motor
NOTE:
Do not disconnect connectors by pulling on cord.
To disconnect the connectors, grasp the connector,
not the cord.
To remove:
1. Remove the belt cover, the top cover and the front
cover (refer to pages 1, 2 and 5).
2. Disconnect the DC motor connector from the printed
circuit board A (refer to page 8).
3. Remove the motor belt.
4. Remove the setscrews (2 pcs), and the DC motor.
To attach:
1. Attach the DC motor and slightly tighten the setscrews.
2. Attach the motor belt and adjust the belt tension.
Push the middle of the belt span with approximately
200 grams-force pressure. Adjust the motor position so
that the belt deects 5 to 7 mm.
3. Tighten the setscrews securely.
4. Connect the DC motor connector to the printed circuit
board A (refer to page 8).
5. Attach the front cover, the top cover and the belt cover.
Setscrew
Setscrew
Motor belt
200 gf pressure
5 to 7 mm