80
LIGHTING: TAILLIGHT
TAILLIGHT (see left)
Your Janus is equipped with a taillight that uses a 12 volt p21/5w incandescent bulb.
WARNING: The bulb andlens become hot during operation. Always allowsufficient time
for the light to cool before servicing.
TAILLIGHT BULB REPLACEMENT
1. Unscrew the two tail light retaining screws.
2. Carefully remove the tail light lens taking care not to lose the clear license plate light lens
which is located at the bottom of the light.
3. Unscrew the bulb and replace with a new bulb.
4. Take care when reassembling the light to reposition the tail light lens correctly and note the
orientation of the taillight lens.
5. Replace and tighten the taillight lens retaining screws.
WARNING: Always replace with the correct bulb specified above. Operation with an
incorrect bulb can under or over-load the electrical system, leading to electrical failure,
loss of control, and anaccident.
LED OPTION: LED bulb replacement is the same as with the incandescent bulb. Only
use LED replacements available from Janus Motorcycles.
To Next Page
Loading...