Janus FM-200 Sv Series - Selector Valve Components

Page: 29
FM-200® OPERATION, DESIGN, & SERVICE MANUAL
Revision F
Document # DOC102
Issued: February 1, 2009
Revised: 11-Nov-2011
40YE
Section 2 System Description and Components
Primary
Cylinder
Slave
Cylinder
Slave
Cylinder
TO ZONE 1
DISCHARGE
NOZZLES
TO ZONE 2
DISCHARGE
NOZZLES
Selector
Valve
Lockout Valve
w/ Limit Switch
Optional
Regulator
(P/N 19170)
Discharge
Relief Valve
450 psi
(P/N 19317)
Discharge
Relief Valve
125 psi
(P/N 19316)
Discharge
Relief Valve
450 psi
(P/N 19317)
Required
when Optional
Lockout Valve
Installed
Discharge
Pressure
Switch
(P/N 18773)
Discharge
Pressure
Switch
(P/N 18773)
Figure 2.5a Selector Valve Arrangement - TYPE A
NOTE: The free ends of the
manifold (marked A and B on the
diagram) cannot exceed half the
width of the agent cylinder.
A
B
2.5 Selector Valve Components
(See Figure 2.5)
Multiple hazards can often be protected with a common set of cylinders by using selector valves. Selector
valves components are required in these specic cylinder arrangements that utilize selector valves to allow
the protection of multiple hazards or hazard zones by one set of FM-200® cylinders.
ere are typically two types of selector valve arrangements utilized for multiple hazard protection with a
common set of agent cylinders.
• TYPE A - e Type A arrangement consists of the selector valves mounted directly on the cylinder
manifold. is arrangement does not require pipe modeling or performing a selector valve manifold
calculation. However, the free ends of the manifold cannot exceed half width of the agent cylinder when
installed using this arrangement. Refer to Figure 2.5a.