Jasic MIG 350 Pulse Separate - Parameter and Material Settings

WWW.JASIC.CO.UK 15
actual welding voltage and the contents of the column parameters. Users can select the desired
parameters by pressing the selecng key, and the corresponding LED will be on when a certain parameter
is selected. Meanwhile, the contents of the selected parameter will be displayed on the meter.
Note: The meter will display the actual voltage when the main power circuit is connected. To modify a
parameter, users should make corresponding LED ash by pressing the selecng key.
Base metal selecng zone
This area contains components such as base metal LEDs
and selecng key. Base metal includes carbon steel,
stainless steel, aluminum alloy, aluminum magnesium
alloy, pure aluminum . Users can select the desired base
metal by pressing the selecng key, and the
corresponding LED will be on when a certain kind of base
metal is selected.
Note: There is no such funcon in MMA .
Gas selecng zone
This area contains components such as gas LEDs and selecng key. Gas
includes 100% CO2, 80% Ar+20% CO2, 90% Ar+5% CO2+5% O2, 98%
Ar+2% CO2 and 100% Ar . Users can select the desired shield gas by
pressing the selecng key, and the corresponding LED will be on when a
certain kind of shield gas is selected.
Note: There is no such funcon in MMA .
Wire diameter selecng zone
This area contains components such as welding wire LEDs and selecng
key. Welding wire includes solid wire of Φ0.8, Φ1.0, Φ1.2 andΦ1.6, ux-
cored wire ofΦ1.0, Φ1.2 and Φ1.6 and Flux cored. Users can select the
desired wire by pressing the selecng key, and the corresponding LED will
be on when a certain kind of wire is selected. The ux-cored wire LED on
indicates that ux-cored wire is selected, while the LED o indicates that
solid wire is selected.
Note: There is no such funcon in MMA .
Parameter adjustment knob
This area contains the parameter control knob and adjustment indicator. All
welding parameters are set by adjusng this knob. The adjustment indicator
tells users that the knob is eecve only when the corresponding parameter LED
in the current column or voltage column ashes.