Jasic MIG 350 Pulse Separate

To Next Page

To Previous Page

WWW.JASIC.CO.UK 17

Select the desired gas type by pressing the selecng key in the gas selecng zone if necessary.

Select the welding wire type

Select the desired welding wire type by pressing the selecng key in the wire selecng zone if necessary.

Select the operaon mode

Select the desired operaon mode by pressing the selecng key in the operaon mode selecng zone if

necessary.

Select the parameter to be viewed or modied

If necessary, select the segment, to which the parameter to be viewed belongs, by pressing the selecng

key in the welding process parameters selecng zone, and then select this parameter by pressing the se-

lecng key in the current column parameters selecng zone or voltage column parameters selecng zone,

and the current value of this parameter will be displayed on the current column or voltage column pa-

rameters display meter. Users can modify this parameter by adjusng the control knob when the corre-

sponding parameter LED ashes.

Jasic MIG 350 Pulse Separate - Page 17