Jasic MIG 350 Pulse Separate - Operation Mode Selection; MIG;MAG Operation Modes; Torch Trigger Operation

WWW.JASIC.CO.UK 24
Operation mode selecting
For MIG/MAG operation modes, see the table below for reference; for torch trigger operation notes, see the torch
trigger table for reference.
MIG/MAG operaon modes
Torch trigger operation
Mode no. Operaon Gun trigger operaon and current curve
1T/Spot welding mode:
Push the torch trigger: arc is ignited and current rises
to the preset value.
When the spot welding time is up, current drops
gradually, and arc stops.
Standard 2T mode:
Push the torch trigger: arc is ignited and current rises
to the initial value, then gradually rises or drops to the
preset value.
Release the torch trigger: current drops gradually, and
arc stops.
4T mode:
Push the torch trigger: arc is ignited and current rises
to the initial value, then rises or drops gradually. The
torch trigger can be released at any time.
Push it again: current gradually drops to crater current
value.
Release it: arc stops.
Programmed 4T mode:
Push the torch trigger: arc is ignited and current
reaches the initial value.
Release it: current rises gradually.
Push it again: current drops to crater current value.
Release it: arc stops.
Push the torch trigger.
Release the torch trigger.
Push the torch trigger and then release it at any time.
Release the torch trigger and then push it at any
time.