Jasic MIG 350 Pulse Separate - Torch and Connection Care

WWW.JASIC.CO.UK 26
water-cooling should be used as long as water-
cooling torch is used.
Unobstructed gas hose and water hose:
If the hose is pressed by heavy things or the hose is
bended, water or gas would stop owing. Thus, the
welding torch would be burned or welding defects
would be produced.
Take good care of the welding torch:
Careless operaon of the welding torch would lead
to wire breaking, water or gas leakage and nozzle
damage easily.
Poor connecon of the gas regulator or gas hose
would lead to gas leakage or gas ow reducing at
the nozzle front, consequently, gas protecon eect
would be weakened, and air holes in the weld bead
would be caused.
Reliable connecon:
The connecon between the welding machine and
the power supply, between the welding machine
and the welding torch, between the welding
machine and the electrode holder, between the
welding machine and the wire feeder and between
the welding machine and the earth cable should be
good, and the connecon of all kinds of control
cables should be good also. Improper connecon
would cause poor contact, which would lead to
malfuncon, resulng in abnormity and burnout,
etc.
Connecon with the work piece:
If someone uses steel plate or steel bar instead of
the cable connecng the work piece, the resistance
would be greater, and the welding current would be
unstable. In addion overheang would lead to a
re hazard. Therefore, please connect the base
metal correctly with normal insulated cable.
Take protecve measures when welding in windy
environment. Otherwise, the shield gas would be
blown away and air holes would be caused.
Clean the base metal before welding if there is any
oil, rust, paint, moisture or other maers on the
surface of it. Otherwise, air holes or cracks would be
caused, and good welding eect could not be
obtained.