Picture 1-6 Current parameters selecting zone
There are current parameters display and
indicator. Current parameters including current (A),
wire feed speed (m/min) and secondary menu can
be selected by rotating the encoder. System
information, actual welding current and functions
classification can be displayed. Corresponding
indicator will be on and information will be
displayed according to selected parameters. When
there is welding current, actual welding current
value will be displayed.
Picture 1-7 Voltage parameters selecting zone
There are voltage parameters display and
indicator. System information and actual welding
voltage can be displayed. Voltage parameters
including voltage (V), time(S), duty ratio (%),
frequency (Hz) and function parameters can be
selected by rotating the encoder, while relevant
information will be displayed based on selected
parameters. When there is welding current, actual
voltage value will be displayed.
Picture 1-8 Operation modes selecting zone
Operation encoder and selection button are
included.
Current setting or secondary menu can be
adjusted by rotating the encoder. Selection button
is pressed to open secondary menu in which
options can be switched by rotating the encoder.
Picture 1-9 Parameters adjusting knob
zone
Operation encoder and selection button are
included.
Voltage setting or plate thickness parameter
(effective only under synergic) can be adjusted by
rotating the encoder. Selection button is pressed to
adjust plate thickness. When plate thickness is
displayed, selection button is pressed again to
switch display.
Picture 1-10 Gas check
There are gas check button and gas check
indicator. Gas check button is pressed to open gas
channel or is released to close the gas channel
indicated by gas check indicator.
Picture 1-11 Synergic
There are synergic button and synergic indicator.
Synergic button is pressed to make synergic
effective and is pressed again to make synergic
ineffective indicated by synergic indicator.
To Next Page
Loading...
