Attached Table 1 TIG operation mode code sequences list
33
Description
(SEE TEXT FOR DETAILS)
Cycle single operation mode
without initial current
Cycle single operation mode
with initial current
Inner timing operation mode
Outer timing operation mode
Cycle double operation mode
without initial current
Cycle double operation mode
with initial current
Real time waveform control
operation mode with initial
current (intermittent up-
down)
Real time waveform control
operation mode without initial
current (intermittent up-
down)
Manual pulsed single
operation mode
Manual pulsed double
operation mode
Pulsed welding with fixed
frequency (5Hz) and fixed
duty cycle (50%)
Pulsed welding with unfixed
frequency (the cycle is 1/5 of
the upslope time) and fixed
duty cycle (50%)
To Next Page
Loading...
