11
CONTROLS
Front view Jasic TIG 300P
1. Digital Control Panel: See page 12 for in depth
explanaon of the controls
2. "+" Output terminal: To connect the work clamp in
TIG mode or the electrode holder in MMA mode
3. "-" Output terminal: To connect the TIG torch or
work clamp in MMA mode
4. 9 pin remote connecon: See page 29 for further
details
5. Gas Outlet: used to connect the gas ng/hose of
the TIG torch
Rear view Jasic TIG 300P
6. Water cooler supply outlet: The oponal cooler plug
will connect to this socket
7. Gas Inlet: The gas supply hose connect to this inlet
8. Mains input supply cable
9. Control Fuse: This fuse is for water cooler output and
is rated at 5amps
10. Mains input ON/OFF power switch
To Next Page
Loading...
