Jasic TIG Series - Page 12

12
CONTROLS
Control panel view Jasic TIG 300P
1. Welding mode selecon zone: Welding mode selecon zone contains welding mode indicators and
selecon key. Welding modes include DC TIG, Pulse TIG, DC MMA. Press the welding mode selecon
key to choose the according welding mode. The welding mode selected will be indicated by the
corresponding LED being lit and there is welding current owing
2. Digital meter: Displays pre-set and actual current before and during welding. Also used to display
parameter adjustment sengs along with any error codes
3. MMA parameter selecon zone: By pressing the switch you will have access to adjust hot start,
current and arc force in MMA mode
4. Parameter selecon area: Pushing the selecon switch (5) will highlight the LED of the parameter to
be adjusted in the selecon area
5. Parameter selecon buon: Press to select the required welding parameter to be adjusted
6. VRD (voltage reducon device) indicator
7. Adjustment control dial: Rotang this dial will adjust selected parameter shown in the digital display
8. CH is the weld parameter recall/storage channel selector
9. TIG torch switch mode selecon area
10. Remote control selecon: Pressing this key will set current control from the panel or a remote device
such as a foot pedal or TIG torch remote potenometer
11. TIG starng mode selecon area (contact or non contact ignion): When you press this switch, you
either select HF arc ignion or li arc TIG mode and the matching indicator will illuminate
12. Cooling selector switch (water or air): Using this switch will turn on/o the ed TIG water cooler and
the matching indicator will illuminate