Jasic TIG Series - Description of Functions

13
FUNCTIONS
Welding mode selecon switch
The welding mode selecon zone contains the welding mode indicators along
with the mode selecon switch for TIG DC, TIG Pulse and MMA welding modes.
Press the welding mode selecon key to choose the according welding mode.
The welding mode being selected LED will be lit when selected and there is
welding current owing.
MMA parameters selecon zone
This area contains the MMA parameters selecon.
1. Ensure you are in MMA mode (as described above).
2. By pressing the key you will circulate through hot start,
current and arc force funcons.
These funcons are not available during TIG and TIGP modes.
The display and parameter area
This area contains the display meter, unit parameters indicators and the warning indicator.
1. The window in the middle is a display to show all user parameters
2. O.C on the le is the over current protecon LED
3. O.C on the le is the over current protecon LED
4. O.H on the le is the over heat protecon LED
5. The A LED on the right is current
6. The S LED on the right is me in seconds
7. The % LED on the right is percentage
8. The Hz LED on the right is frequency respecvely
9. Error codes will also be shown on this display
Selector switch
This buon is used to navigate around the control panel.
VRD Indicator
The VRD LED will be lit when the machine is in MMA mode and the VRD funcon is enabled.
Parameter adjustment rotary knob
Parameter adjustment rotary knob is for adjusng all welding parameter
available to the user.