Jasic TIG Series - TIG Operation Steps

22
OPERATION - TIG
Before starng any welding acvity ensure that you have suitable eye protecon and
protecve clothing. Also take the necessary steps to protect any persons within the welding
area.
TIG operaon steps
Select the DC TIG mode by pressing the welding mode selecng key.
Select the 2T mode by pressing the operaon mode selecng key.
Select the pre ow me seng funcon by
pressing the parameter selecng key unl the
T pre LED illuminates. The pre ow me range
is 0~15 seconds and is adjusted via the control
knob and the pre ow me is shown on the
front panel digital display.
Select the inial current seng funcon by
pressing the parameter selecon key unl the
Is LED Illuminates. The inial current range is
0~60amps and is adjusted via the control
knob and the amperage is shown on the front
panel digital display. The inial current
amperage can be adjusted during welding.
Select the upslope me seng funcon by
pressing the parameter selecon key unl the
Tup LED Illuminates. The upslope me range is
0~10 seconds and is adjusted via the control
knob and the me is shown on the front panel
digital display.
Select the peak current seng funcon by
pressing the parameter selecon key unl the
Ip LED Illuminates. The peak current range is
5~300amps and is adjusted via the control
knob and the amperage is shown on the front
panel digital display. The peak current
amperage can be adjusted during welding.