Jasic TIG Series - TIG Cycle and Spot Modes

28
OPERATION - TIG
Before starng any welding acvity ensure that you have suitable eye protecon and
protecve clothing. Also take the necessary steps to protect any persons within the welding
area.
TIG torch trigger operaon steps
Cycle mode
The cycle ↕↕ (□) LED light will illuminate when the power source is in repeang mode, upon pressing the
torch trigger switch the gas valve opens and aer the pre ow me ends, HF discharge will engage the
welding arc. Once the welding arc is ignited successfully, the inial current is present then aer the
operator releases the torch switch the
welding current rises up to the preset
welding current value gradually
(depending on preset upslope me).
When the torch switch is pressed down
again, the current begins to drop
gradually to the nal current arc value.
When the torch switch is released again,
the current will rise gradually up to the
welding current value again. ‘Cycle’
means the welding current varies
between the nal arc current value and
the welding current value.
To exnguish the welding arc, press and release the torch trigger briey (within 1/5 of a second) and the
arc will be exnguished immediately and the current output will be shut o. The gas valve will then close
when the post ow me ends and the welding process ends.
Spot welding mode
The spot ••• LED will illuminate when the
power source is in spot welding mode.
To set the spot welding me seng, refer
to page 24 for selecng and seng the
spot me.
On pressing the torch trigger, gas will ow
and at the end of the gas pre ow me HF
will iniate the welding arc.
Once the welding arc is ignited the
welding current is present and no maer
if the torch switch is on or o the machine
will sll oer welding current unl the
preset spot welding me the user set has
med out and then the welding arc will be exnguished. The gas will connue unl the post ow me
ends when the welding process ends.
Please note:
Spot welding can only be carried out in HF TIG mode only.