Jasic TIG Series - Remote Control Socket

29
REMOTE CONTROL SOCKET
The Jasic TIG 300P is ed with 9 pin remote control socket located on the front panel which is used to
connect various TIG remote control opons, for example, a TIG torch trigger switch a TIG torch mounted
current adjustment dial as well as a foot pedal or other similar remote device.
When ng the 9 pin remote plug, ensure you align the keyway when inserng the plug, then rotate the
threaded collar fully clockwise unl nger ght.
To select the appropriate
remote current control process,
press the remote buon unl
the LED is lit alongside your
chosen preference.
The 9 Pin plug & clamp Pt No
is JSG-PLUG-9PIN
Remote device acvaon
Without welding, press the remote unl the panel LED is lit, this indicates that the machine
is ready for front panel current control.
Without welding, press the remote unl the remote LED is lit, this indicates that the
machine is ready for an analog (potenometer type) type torch control.
Without welding, press the remote unl the foot pedal remote LED is lit, this indicates that
the machine is ready for a foot pedal type control.
Starparts Titanium Torch (Trigger only) wiring as follows:
Pin 8 - Trigger
Pin 9 - Trigger
Starparts Titanium Torch with analog remote current control
Jasic JFC-08 Foot pedal wiring are as follows:
Pin 1 – Potenometer Max
Pin 2 – Potenometer Wiper
Pin 3 – Potenometer Min
Pin 8 – Trigger
Pin 9 – Trigger
Starparts Titanium Torch with digital current control wiring
as follows:
Pin 4 – +
Pin 5 – -
Pin 6 – Parameter selecon
Pin 8 – Trigger
Pin 9 – Trigger (Common)
9 Pin Remote socket conguraon
Pin No Descripon
1 Potenometer (min)
2 Potenometer wiper
3 Potenometer (max)
6 N/A
7 N/A
8 Torch switch
9 Torch switch
+
-
Parameter
selecon
Switch