Jasic TIG200 - Control Panel; HD Digital Panel Overview

Page 21
2) Remove the buckle on the front panel inside the machine and pull out the wireless plug
cover.
3) Insert the wireless receiving module into the front panel, then connect the connection line
of the receiver module to the CN10 socket on the mainboard.
Note! Check with the seller whether the hardware and software versions of the
machine support wireless remote controller before purchasing.
6. Control panel
6.1. TIG200/TIG200PFC HD digital panel
Figure 6-1 HD digital panel
1. TIG parameter display
2. Parameters and error code display
3. Protection indicator
4. Welding mode selector
5. Arc start mode selector
6. Enable remote control
7. Smart gas
8. Parameter adjustment knob
9. VRD function indicator