quickly,to help you get the more steady signal.
5.Pinpoint the target
When there is a clear signal to show you the location of the buried target
objects,you can “X” the target at different angles to zero on the exact spot on the
ground where the “beep” occurs. You can do a "X" scan in this district, generally the
bottom of the intersection point is the target object.(Fig 12)
Fig.12
6.Power off prompt
If you forget to power off the metal detector after use, the metal detector will
emit three short beeps every 10 minutes, and start the automatic scanning procedure
as power on to remind you power off the unit in time.
12
To Previous Page
Loading...