Target categories Indication sound TARGET ID indication
Iron nail Low tone
IRON is illumined and flickered
about 5 seconds
Nickel,coins Medium tone
MID RANGE is illumined and
flickered about 5 seconds
25 cents High tone
SILVER is illumined and flickered
about 5 seconds
3， Four kinds of discrimination modes
The detector is automatically set to the ALL METAL mode,when it’s powered
on,n amely it will respond to all types of metals. Press the “MODE” button,it will
eliminate the metals that you don’t want, press“MODE”button for several times,the
operator can choose from the four kinds of different discrimination settings.
Four kinds of modes Indication sound
TARGET ID
indication
The Eliminated
metals
Initial state High tone Not illumined
Can’t eliminate any
metals
press“MODE”button Low tone Iron is illumined Iron is eliminated
press“MODE” button
again
Medium tone
Mid range is
illumined
Nickel, Coins
press“MODE”button
again
Low tone and
medium tone by
turns
Iron and Mid
range are all
illumined
Iron, nickel, coins
are eliminated at the
same time
press“MODE” button
again
High tone Not illumined
Can’t eliminate any
metals and in the
ALL METAL state
Note:the times of the detector sounding the tone is the same with the sensitivity
level,which means when the sensitivity is at the fourth level,the detector will sound
four times.
Quick Start
1. Lay the metal detector properly
In order to avoid the metals influencing the detector, be sure to lay the the
metal detector properly. Place the detector on a wooden or plastic table. Let the
search coil exceed the table edge about more than 15cm, and adjust the search
coil so that the flat part points upwards.(Fig 9)
6
To Next Page
Loading...