Jaycar Electronics QP2303 - Page 8

When turning on the unit, the detector is at the ALL METAL state,sweep the
metal sample above the center of the search coil (5cm)
Operate
Indicatio
n tone
LCD
TARGET
ID
LCD
DEPTH-
SENS
Chart Note
Turn on
Turn on
indicatio
n
Nothing
displayed
SENS-3
is illuminated
Sweep
iron
nail
a low
tone
The IRON
is
illuminate
d and
flicker
DEPTH-2
is illuminated
and flickers
Nickel,
coins
a
medium
tone
MID
RANGE
is
illuminate
d and
flickers
DEPTH-2
is illuminated
and flickers
Silver
a high
tone
SILVER
is
illuminate
d and
flicker
DEPTH-2
is illuminated
and flicker
If the height of
the metal
sample from
the search coil
is changed, the
lighted
segments of the
LCD height
mark cursor
will be changed
correspondingl
y.
5． Eliminate iron
Operate
Indicatio
n tone
LCD
TARGET ID
LCD
DEPTH-SENS
Chart Note
Press
MODE
button
Three
low
tones
IRON SENS-3
is illuminated
Press the
MODE
button,the
times of
the
detector
dh
8