36
The recreation vehicle is parked on a reasonably level surface.
Transmission should be in PARK.
Apply the parking brake.
Be sure the batteries have been fully charged.
Turn o all lights and other electrical elements during operation.
Minimize movement inside the coach when in auto leveling mode.
Be sure all persons, pets, and property are clear of the motor home while the sys-
tem is in operation.
Turns the leveling system ON/OFF.
Allows you to manually level the RV.
Places the system in AUTO LEVEL mode.
Allows the user to retract all jacks.
When in MANUAL mode, press the RETRACT button and hold it until desired
levelers are retracted.
When in AUTO mode, simply push the RETRACT button one time.
Allows the user to retract the jacks when there is a false ALL
UP light. The jacks will retract and override the ALL UP light. The button must be pressed
and held until all jacks are retracted and the control panel automatically turns OFF.
1. Press the POWER button to turn the panel/system ON. LED beside the button will il-
luminate. (System will with the ignition key ON).
2. Let the system run through the diagnostic mode (lights will ash clockwise around the
green foot).
3. When in MANUAL mode, each leveler may be operated individually.
• FRONT operates right front
• RIGHT operates right rear
• REAR operates left rear
• LEFT operates left front
4. When using this feature it is important to level the coach by using two levelers at a time
or together. For example, right front and right rear. as this puts less stress on the frame.
• To retract individually, press and hold the RETRACT button and the desired jack
button together.
• To retract all jacks, press and hold MANUAL until the light goes o, then press
RETRACT.
5. When using the AUTOMATIC feature, simply press the AUTO LEVEL button and let
the system operate itself. It is important at this time there is NO MOVEMENT IN THE
COACH. This process will take 1-3 minutes.
6. To retract the levelers simply press the POWER button and turn the system ON, and
press RETRACT.
1. Press the POWER button to turn the panel/system ON.
2. Let the system run through its diagnostic mode (lights ash clockwise around the green
foot).
To Next Page
Loading...
Need help?
General
