JBL Harman PartyBox On-The-Go User Manual

1111
www.jbl.com
English
6.5.1 Connecting a Microphone
To connect the supplied wireless microphone
By default, the wireless microphone comes pre-paired with the
speaker at factory.
GUITAR
BASS
TREBLEECHO
GUITAR
MIC
MIC
BASS
BOOST
2
1
CH1 CH2... CH6
x 1
< 10 m (33 ft)
1. Load the two Alkaline AA batteries with correct polarity.
2. Turn on the speaker and supplied wireless microphone
successively.
J Wireless connection will be set up automatically.
Notes:
– The microphone powers off automatically after 10 minutes of
inactivity.
– A maximum of two wireless microphones are supported. Contact
your dealer for how to purchase more.
To connect a wired microphone (not supplied)
BASS
TREBLE
BASS
BOOST
To connect a new wireless microphone
1. Turn off the speaker.
2. Turn on the new wireless microphone and place it on the top
of the speaker.
3. Turn on the speaker.
J The microphone will pair and connect with the speaker
automatically within 3 minutes.
To replace wireless microphone batteries
Cautions:
– Do not mix batteries (old and new or carbon and alkaline, etc.).
– Remove batteries if they are exhausted or if the microphone is not
to be used for a long time.
– Batteries contain chemical substances, they should be disposed of
properly.
1. Check the battery level.
100%
<5%
2. If the battery level is low, replace the old batteries with new
ones.

JBL Harman PartyBox On-The-Go Specifications

General

Brand	JBL
Model	Harman PartyBox On-The-Go
Category	Portable Speakers
Language	English