Need help?Do you have a question about the JBL STADIUM UB4100 and is the answer not in the manual?
General| Impedance | 2 ohms |
|---|---|
| Bluetooth | Yes |
| Auxiliary Input | Yes |
| Wireless Subwoofer | No |
| HDMI Input | No |
| HDMI Output | No |
| Optical Input | No |
| USB Port | No |
| Wall Mountable | Yes |
| Type | Soundbar |
Configure input level, auto turn-on, and gain settings before rear bridge plate installation.
Secure the soundbar to the mounting bar using bracket bolts and adjustment screws.
Route and secure safety harness wires using clamps to the soundbar and mounting bar.
Connect RCA line outputs or speaker wires from the head unit to the soundbar's audio input.
Connect a mobile device's headphone port to the soundbar's 3.5mm audio cable.
Connect a subwoofer or amplifier to the soundbar's gray RCA audio output cable.
Connect ground, +12V power, illumination, and remote turn-on wires to the vehicle.
Insert fuse, reconnect battery, and pair Bluetooth remote.
Operate the soundbar using the rear-panel power switch and standby button.
Understand input priority for 3.5mm, Bluetooth, and RCA audio sources.
Pair a Bluetooth device with the soundbar by pressing the Bluetooth button.
Connect up to 3 Bluetooth devices for shared playback and song switching.
Adjust the soundbar's volume based on the connected source device's volume.
Use the remote for volume, track skipping, play/pause for Bluetooth sources.
Control soundbar lighting modes (Ext, Auto, Off) and brightness levels.
Access and understand settings like Input Level, Auto Turn-On, and Gain Control.
Check power, ground, fuse, and remote wire connections for no sound.
Check source volume, 3.5mm cable connection, and Bluetooth pairing for no sound.
Verify vehicle voltage, check for overheating, or contact dealer if indicator flashes.
Ensure soundbar gain is set appropriately and vehicle voltage is correct.
Check source device and soundbar gain control for distorted audio.
To Next Page
