EasyManua.ls Logo

jcb XR Series - Introduction; About this Manual; Units of Measurement; Warranty

jcb XR Series
132 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INTRODUCTION
1 1
About this Manual
This document details the relevant use and maintenance
procedures for the JCB Trencher. The safety information
included is directly relevant to operation and maintenance
of the Trencher. General safety information, and that
relevant to the carrier machine is not included. For details
about safe operation of the carrier machine, see the
relevant documents.
DO NOT ATTEMPT TO INSTALL, OPERATE OR
MAINTAIN ANY ATTACHMENT UNTIL YOU HAVE READ
AND UNDERSTOOD ALL RELEVANT OPERATOR
DOCUMENTATION FOR BOTH THE ATTACHMENT, AND
THE CARRIER MACHINE. PAY PARTICULAR
ATTENTION TO SAFETY INFORMATION. YOU MUST
OBSERVE ALL RELEVANT LAWS AND REGULATIONS.
The manufacturer’s policy is one of continuous
improvement. The right to change the specification of the
machine without notice is reserved. No responsibility will
be accepted for discrepancies which may occur between
specifications of the machine and the descriptions
contained in this publication.
Units of Measurement
In this manual, the S.I. system of units is used. For
example, liquid capacities are given in litres. The Imperial
units follow in parenthesis ( ), for example 28 litres
(6 UK gal/7.2 US gal)
Warranty
A copy of the manufacturer's warranty is provided at the
rear of this manual. We advise you to read and understand
the warranty before using the machine.
Carrier Machine Suitability
The Trencher is suitable for use with the JCB Robot Skid
Steer Loaders and 1CX Backhoe Loaders according to the
following table
The Trencher is suitable for use with some other non JCB
carrier machines. See the specification section for details
of typical carrier requirements.
Note: If fitting XR35 onto an early JCB Mk1 Robot
185HF - 1110HF 1” Quick Release couplings were used
and the additional parts listed below are required, as
follows:
1 x 1406/0026 - 1in BSP Bonded Washer
1 x 45/910100 - 1 in BSP Female Quick Release Connector
1 x 1606/0012 - 1 in BSP - 3/4 in BSPMale-Male Adaptor
A1461-1
JCB Trencher
Carrier XR-35 XR-21 XR-14
Robot 185 HF, 190HF, 1105HF, 1110HF 980/A1452
Robot 185, 190, 1105, 1110 980/A1451
Robot 170HF, 165HF, 160HF 980/A1451
Robot 170 980/A1450
Robot 165 980/A1450
Robot 160 980/A1450
Robot 150 980/A1450
1CX HF (208 HF USA) 980/A1451
1CX (208 USA) 980/A1450
Includes
USA
Machines

Table of Contents

Related product manuals