Risks caused by vibrations
The vibration values specified in the technical data represent the main uses of the device.
The actual existing vibrations during use may deviate from these as a result of the following
factors:
•
Incorrect use of the product;
•
Unsuitable tools inserted;
•
Unsuitable material;
•
Insufficient maintenance.
You can reduce the risks considerably by following the tips below:
•
Maintain the device in accordance with the instructions in the operating instructions.
•
Avoid working at low temperatures.
•
When it is cold, make sure your body and your hands, in particular, are kept warm.
•
Take regular breaks and move your hands at the same time to promote circulation.
Electrical safety
•
The device may only be connected to a socket that is correctly installed and grounded.
•
The fuse must be a residual current circuit- breaker with a measured residual current of no
more than 30 mA.
•
Make sure that the power supply corresponds with the connection specifications of the
device before it is connected.
•
The tool may only be used within the specified limitations for voltage and power (see type
plate).
•
Do not touch the mains plug with wet hands! Always pull out the mains plug at the plug
and not by the cable.
•
Do not bend, crush, pull or drive over the power cable, protect from sharp edges, oil and
heat.
•
Do not lift the device using the cable or use the cable for purposes other than intended.
•
Check the plug and cable before each use.
•
If the power cable is damaged immediately dis- connect the plug. Never use the device if
the power cable is damaged.
•
If the device is not in use make sure the plug is pulled out.
•
Make sure that the device is switched off before plugging in the mains cable.
•
Make sure that the device is switched off before unplugging it.
•
Disconnect the power supply before transporting the device.
Device-specific safety instructions
• Keep the handles dry and free of grease.
• Make sure to always wear personal protective clothing when operating.
• Make sure the connection cable is always kept out of the working range of the device.
Make sure that cables always lead away from the rear of the device.
• Make sure you are positioned firmly and with a natural stance when working with the
device.
• Always hold the unit tightly with both hands.
• Before starting work, check the area for animal and objects. Remove all objects that may
be blown away by the unit, or that the thread may become caught on.
• Before starting work check the area and remove all objects which may damage the
cutting mechanism.
• Always ensure sufficient distance to the cutting mechanism.
• In the vicinity of 15m around the cutting area there should be no people or animal as
they may be hurt by flying objects.
• Only work with good light and visibility.
• Do not work above hip height! Do not bend for- wards or lean over backwards!
• The clothing of the operator should be close-fit- ting. Avoid wearing loosely fitting
clothing. Wear sturdy footwear and long work trousers.
• Pay attention when walking backwards. Danger of stumbling!
• The cutting tool will continue to rotate even after the engine has been switched off.
• Risk of injury caused by the cutting blades! After pulling out a new thread, always keep
the machine in the normal working position before switching on.
To Next Page
Loading...