Jebao JGP Series - User Manual

Jebao Pond Pump JGP series
Please read these Instructions completely before using one of the jebao pond pumps in below
table.
Model Rated voltage
rated current
Motor
Flow
Max. Total Max.
input head operation
depth
JGP15000
120V,60Hz 2. 55A EM-15000
15000Llh
8.5m 2m
JGP20000
120V,60Hz 3. 55A EM-20000
20000Llh
7.5m 2m
JGP25000 120V,60Hz 3. SA EM-25000
25000Llh
S.5m 2m
JGP30000 120V,60Hz 4. 5A EM-30000
30000Llh
9.0m 2m
These pumps are used as submersible and non-submersible pumps provided with overload-protected
devices in garden ponds, fountains, terraced fountains, indoors fountains to circulate and oxygenate
clear water. You can use the suction cups or four screws to fix it. It is fixed to any appropriate bases.
Make sure that the appliance is securely installed before operating it.
These pumps are not for use in swimming pools!
CAUTION: These Pumps should be installed according to your local electrical
installation code. Please contact an electrician.
For all technical data, please refer to the content stated on th e rating label of the pump.
Safety instructions
• Read and observe all the instructions supplied with the appliance and on the appliance.
• Make sure that you outlet voltage corresponds to the stated on the rating label of the pumps.
• Make sure the appliance is securely installed before operating it.
• The electrical connection should be located in a water-proof area and should be at least 2 meters
(6 feet) away from the edge of the pond (see fig.1).
• Keep the electrical connections dry! Ensure that the electrical cord loops below the electrical
outlet to form a "Drip Loop". This will prevent water from running down the cord into the electrical
outlet.
• Always unplug the appliance when not in use, before putting on or taking off parts, before
cleaning the pumps and before doing any work for the fountain or pond.
• The pump must not be used when people are working in water. Please disconnect the pump first.
• Do not operate any appliance with a damaged cord or plug, or in abnormal state. The supply cord
of the appliance cannot be replaced. If the cord is damaged the appliance should be
scrapped.
• For safety reasons, any repair work should be done only by the manufacturer of the products or
the authorized service facility or discard it.
• Never hang or transport the pump by means of pulling the power cord!
• Close supervision is necessary when the appliance is used by or near children.
www.allpondpumps.com
2015
1

Jebao JGP Series Specifications