Jeco FCL039 - Assembly Instructions; Step 1: Route Water Hose; Step 2: Connect Pump and LED Lights; Step 3: Fill Basin and Submerge Pump

Current instructions at www.jeco-inc.com 1-800-893-3006 Page 2 of 3
To Assemble:
Step 1: Route the pre-assembled water hose on the top square pot (A) to the bottom (B).
Step 2:
A: Carefully attach the pump (C) to the hose, making sure to place the pump in the center
of the bottom (B).
B: Carefully connect the LED lights (D) to the light cable comes out from pump (C),
making sure both parts connect securely.
Step 3: Fill the basin (B) with clean water, making sure the pump (C) is fully submerged.
Note: The maximum water level should be approximately 1.2 inches below the top edge of
the basin (B).