Jeco FCT109 - Assembly Instructions; Step 1: Connect Pump; Step 2: Fill Basin; Step 3: Connect Power

Current instructions at www.jeco-inc.com 1-800-893-3006 Page 2 of 3
To Assemble:
Step 1: Carefully attach the pump (B) to the tube from the lighthouse (A), place the pump
(B) in the center bottom of basin (A).
Step 2: Fill the plastic basin (A) with clean water, make sure the pump (B) is fully
submerged.
Note: The maximum water level should be approximately 1.2 inches below the top edge
of the basin (A).
Step 3: Finally, connect the plug of pump (B) to a GFCI outlet.
WARNING: Always disconnect the pump (B) before placing your hands in the water.