c. Lay the soft top back into the vehicle with the
curved portion of the bows facing upward.
d. Tap the knuckles on the side with a rubber mallet
to reattach them to the pivot bracket.
e. Screw the pivot screws back into place. Secure
them until they are snug being careful not to cross-
thread the screws.
CAUTION!
Do not overtighten the screws. You can strip the
screws if they are overtightened.
5. Unsnap and remove the black boot cover. This cover
should be discarded. It was intended as a protective
cover for shipping only.
NOTE:
A visual instruction sheet is enclosed in the dual
top wrap.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 69
3
To Next Page
Loading...
