To Turn Off “Flash Lights With Lock”
NOTE: The “Flash Lights With Lock” feature can be
turned on or off using the following steps:
1. Press the UNLOCK button for 4 to 10 seconds.
2. While the UNLOCK button is pressed, (after four
seconds) press the LOCK button. Release both buttons.
3. Test the “Flash Lights With Lock” feature outside of
the vehicle, by pressing the LOCK button with the
ignition in the LOCK position, and the key removed.
NOTE: Pressing the LOCK button, while you are in the
vehicle, will activate the Vehicle Security Alarm. Opening
a door with the Vehicle Security Alarm System activated
will cause the alarm to sound. Press the UNLOCK button
to deactivate the Vehicle Security Alarm.
The “Flash Lights With Lock” feature can be reactivated
by repeating this procedure.
Programming Additional RKE Transmitters
Vehicles will be shipped from the assembly plants with
two key RKE transmitters programmed only for that
vehicle. A total of eight RKE transmitters can be pro-
grammed for your vehicle. Additional RKE transmitters
can be programmed to your vehicle through the use of a
currently programmed RKE transmitter.
NOTE: When entering the program mode using that
RKE transmitter, all other programmed RKE transmitters
will be erased and you will have to reprogram them for
your vehicle.
If the vehicle is not equipped with a Sentry Keyt, use the
following procedure to program additional RKE trans-
mitters:
1. Enter the vehicle and close all of the doors.
22 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
To Next Page
Loading...
