2. Fasten your seat belt (fastening the seat belt will cancel
any chiming that may confuse you during this program-
ming procedure).
3. Place the ignition key into the ignition.
4. Turn the ignition to the ON position. Do not start the
engine.
5. Press and hold the UNLOCK button.
6. After holding the UNLOCK button for four seconds,
also press the PANIC button within six seconds.
7. When a single chime is heard, release both buttons.
The chime is an indication that you have successfully
entered program mode. All RKE transmitters that are to
be programmed must be done so within 60 seconds of
when the chime was heard.
8. Using the RKE transmitter to be programmed, press
and release both the LOCK and UNLOCK buttons,
simultaneously.
9. A single chime will be heard.
10. Within four seconds of hearing the chime, press and
release the UNLOCK button.
11. A single chime will be heard.
12. Repeat Steps 8 through 10 to program up to six
additional RKE transmitters.
13. Turn the ignition to the OFF position.
14. Your vehicle will remain in program mode up to
60 seconds from when the original chime was heard.
After 60 seconds, all programmed RKE transmitters
function normally.
NOTE: If you do not have a programmed RKE trans-
mitter, contact your authorized dealer for details.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 23
2
To Next Page
Loading...
