DOORS
CAUTION!
Careless handling and storage of the remov-
able door panels may damage the seals,
causing water to leak into the vehicle’s inte-
rior.
Upper Half Door Window Removal
— If Equipped
Grasp the half door window and pull upward.
Upper Half Door Window Installation
— If Equipped
1. Grasp the half door window and line up the
pins with the pockets in the lower door.
2. Push down to ensure the half door window is
fully seated.
Front Door Removal
WARNING!
Do not drive your vehicle on public roads
with the doors removed as you will lose the
protection that they can provide. This proce-
dure is furnished for use during off-road
operation only.
1. Remove the hinge pin screws from the upper
and lower outside hinges (using a #T50 Torx姞
head driver).
Hinge Pin Screw
2. Unplug the wiring harness connector under
the instrument panel by pressing the tab at the
BOTTOM of the connector and pull to discon-
nect.
Upper Half Door Window
19
PAGE POSITION: 21 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
To Next Page
Loading...
