• If the shoulder belt contacts the face or neck,
move the child closer to the center of the
vehicle. Never allow a child to put the shoul-
der belt under an arm or behind the back.
Installing The Child Restraint System
We urge you to carefully follow the directions of
the manufacturer when installing your child re-
straint. Many, but not all, restraint systems will
be equipped with separate straps on each side,
with each having a hook or connector for attach-
ment to the lower anchorage, and a means for
adjusting the tension of the strap. Forward-
facing toddler restraints and some rearward-
facing infant restraints will also be equipped
with a tether strap having a hook for attachment
to the tether strap anchorage, and a means for
adjusting the tension of the strap.
In general, you will first loosen the adjusters on
the lower and tether straps so that you can more
easily attach the hook or connector to the lower
and tether anchorages. The tether strap should
be routed under the center of the head restraint
and attached to the tether anchor on the rear of
the seatback. Then tighten all three straps as
you push the child restraint rearward and down-
ward into the seat.
Not all child restraint systems will be installed as
we have described here. Again, carefully follow
the instructions that come with the child re-
straint system.
NOTE:
If your child restraint seat is not ISOFIX-
compatible, install the restraint using the
vehicle seat belts.
WARNING!
An incorrectly anchored tether strap could
lead to increased head motion and possible
injury to the child. Use only the anchor
position directly behind the child seat to
secure a child restraint top tether strap.
Mass Group
Seating Position
Front Pas-
senger
Rear Out-
board
0-Upto
10 kg
XU
0+-Upto
13 kg
XU
I-9to
18 kg
XU
II-15to
25 kg
XU
III-22to
36 kg
XU
43
PAGE POSITION: 45 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
To Next Page
Loading...
