“Driver Information Display (DID)” for further informa-
tion. When the shift lever is moved to REVERSE and the
system is disabled, the EVIC/DID will display the
“PARKSENSE OFF” message for as long as the vehicle is
in REVERSE.
The ParkSense switch LED will be ON when ParkSense is
disabled or requires service. The ParkSense switch LED
will be OFF when the system is enabled. If the ParkSense
switch is pushed, and requires service, the ParkSense
switch LED will blink momentarily, and then the LED
will be ON.
Service The ParkSense Park Assist System
During vehicle start up, when the ParkSense System has
detected a faulted condition, the instrument cluster will
actuate a single chime, once per ignition cycle, and it will
display the ⬙PARKSENSE UNAVAILABLE WIPE REAR
SENSORS⬙, ⬙PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS⬙,orthe⬙PARKSENSE UNAVAIL-
ABLE SERVICE REQUIRED⬙ message for five seconds.
When the shift lever/gear selector is moved to Reverse
and the system has detected a faulted condition, the
Electronic Vehicle Information Center (EVIC) or Driver
Information Display (DID) will display a ⬙PARKSENSE
UNAVAILABLE WIPE REAR SENSORS⬙, ⬙PARKSENSE
UNAVAILABLE WIPE FRONT SENSORS⬙ or
⬙PARKSENSE UNAVAILABLE SERVICE REQUIRED⬙
pop up message for five seconds. After five seconds, a car
graphic will be displayed with ⬙UNAVAILABLE⬙ at ei-
ther the front or rear sensor location depending on where
the fault is detected. The system will continue to provide
arc alerts for the side that is functioning properly. These
arc alerts will interrupt the ⬙PARKSENSE UNAVAIL-
ABLE WIPE REAR SENSORS⬙, ⬙PARKSENSE UNAVAIL-
ABLE WIPE FRONT SENSORS⬙,or⬙PARKSENSE UN-
AVAILABLE SERVICE REQUIRED⬙ messages if an object
is detected within the five second pop-up duration. The
252 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Next Page
Loading...
