Fold And Tumble Rear Seat —
Two Door Models
Folding The Rear Seat
1. Lift the seatback release lever, located on
the seatback between the head restraints,
and fold the seatback forward.
2. Slowly flip the entire seat forward.
3. Use the two retention straps located on the
back of the rear seat and two corresponding
wire loops located on the back of each
b-pillar, and thread the hook-and-loop fas-
teners on the straps through the loops to
secure the seat in the folded position.
For further information, and applicable warn-
ings and cautions, please refer to the Owner’s
Manual at www.mopar.com/en-us/care/
owners-manual.html (U.S. Residents) or
www.owners.mopar.ca (Canadian Residents).
Folding Rear Seat — Four Door
Models
To fold the seat, lift upward on the seatback
release lever, located on the outboard sides of
the rear seat, and slowly fold down the seat-
back. The head restraint will fold automatically
with the seat when this lever is pulled.
Rear Seat Tumble Position Retention Strap
Seatback Release Lever
1 — Seatback Release Lever
2 — Head Restraint Release Lever
To Next Page
Loading...
