IN CASE OF EMERGENCY 251
2. By pushing the electrical connector tab
remove the electrical connector.
Reverse Light Assembly
3. Rotate the bulb counterclockwise, and then
replace the bulb.
4. Insert the new bulb in the socket, making
sure the bulb is locked into place.
5. Reconnect the electrical connector.
6. Reinstall the access door.
Center High Mounted Stop Lamp (CHMSL)
The CHMSL is LED. For replacement see an
authorized dealer.
License Plate Lights
To replace the bulbs proceed as follows:
1. Using a suitable tool remove the license
plate lens.
License Plate Light Location
License Plate Light
2. Remove the bulbs from the individual side
contacts.
3. Insert the new bulbs, and ensure that they
are properly locked between the contacts.
4. Reinstall the license plate lens.
NOTE:
If removing the license plate lens using a screw-
driver, be sure to cover the tip of the screwdriver
with a cloth so no damage is done to the lenses
or the vehicle paint.
1 — Bulb
6
20_BV_OM_EN_USC_t.book Page 251
To Next Page
Loading...
