DISASSEMBLY AND ASSEMBLY
TRANSMISSION
DISASSEMBLY
(1) Remove torque converter.
(2) Remove clamps attaching wire harness and
throttle cable (Fig. 95) to transmission.
(3) Remove shift lever from manual valve shaft at
left side of transmission.
(4) Remove park/neutral position switch.
(5) Remove speed sensor.
(6) Remove converter housing bolts and remove
housing (Fig. 96) from case.
(7) Remove adapter housing, speedometer drive
gear, and speed sensor rotor.
(8) Remove transmission oil pan, oil screen and
screen gaskets (Fig. 97).
Fig. 95 Typical Harness And Cable Clamp
Attachment
1 – CLAMP
2 – THROTTLE CABLE
3 – TRANSMISSION HARNESS
Fig. 96 Converter Housing Removal
1 – CONVERTER HOUSING
Fig. 97 Removing Oil Screen
1 – OIL SCREEN BOLTS
2 – OIL SCREEN
XJ AW–4 AUTOMATIC TRANSMISSION 21 - 269
To Next Page
Loading...
