NOTE:
Before programming your key fob you must
select the “Linking And Unlinking The Remote
Keyless Entry Key Fob To Memory” feature
through the Uconnect system.
To Create A New Memory Profile
1. Cycle the vehicles ignition to the OFF posi-
tion.
2. Select the desired memory profile 1 or 2.
3. Push and release the S (Set) button on the
memory switch.
4. Within five seconds, push and release either
of the memory buttons (1) or (2). The instru-
ment cluster display will show which
memory position has been set.
NOTE:
Memory profiles can be set without the vehicle
in PARK, but the vehicle must be in PARK to
recall a memory profile.
For further information, and applicable
warnings and cautions, please refer to the
Owner’s Manual at www.mopar.com/en-us/care/
owners-manual.html (U.S. Residents) or
www.owners.mopar.ca (Canadian Residents).
Wiper/Washer Controls
The windshield wiper/washer controls are lo-
cated on the multifunction lever on the right
side of the steering column.
Multifunction Lever
1 — Rear Washer (Push Forward)
2 — Lift Up For Mist
3 — Front Washer (Pull Toward Driver)
WINDSHIELD WIPER/WASHER
FEATURES
To Next Page
Loading...
